Ryobi P600 English Manual - Page 16
Optional Woodworking Sub-base, Warning, Attaching The Woodworking Sub-base, Accessory, And Handles - router
View all Ryobi P600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
OPERATION OPTIONAL woodworking Sub-base Turn the P600 laminate trimmer into a trim router with the optional woodworking sub-base, Ryobi Part No. 200334001. The woodworking sub-base accessory with handles is convenient when routing 4 in., 5 in., or 6 in. circular grooves. It can also be used when routing grooves parallel to the edge of the workpiece or with ball-bearing piloted bits. The handles allow you to grasp and hold the trimmer with two hands, similar to grasping and holding a router. This trimmer is designed for roundover and other edging operations up to 3/8 in. It is also useful for rabbeting or dado operations with straight bits up to a maximum diameter of 1/4 in. WARNING: Do not use straight bits larger than 1/4 in. or edging bits which cut a pattern larger than 3/8 in. with this trimmer. Use of larger bits can result in loss of control and serious personal injury. WARNING: Always use the laminate sub-base for laminate trimming. Always use the woodworking sub-base for trim routing operations. Use of the trimmer without a sub-base or using the incorrect sub-base can result in serious personal injury. WARNING: Never install a bit larger than the opening of the trimmer base. The use of larger bits can result in loss of control and possible serious personal injury. trimmer Handle(S) R3 R2 1 2 R2 WOODWORKING Sub-base accessory Sub-base Screw(S) 1 3/14/12/4 Fig. 11 rout circular groove clockwise AttachING the woodworking Sub-base ACCESSORY AND HANDLES See Figure 11. n Turn the switch to OFF and remove the battery pack from the trimmer. n Turn the trimmer upside down to remove the four subbase screws and laminate sub-base. n Attach the woodworking sub-base accessory using the same four screws. n Tighten the screws securely. Do not overtighten. n Turn the trimmer upright and thread the handles provided finishing nail R3 R2 1 2 R2 into the threaded holes in the woodworking sub-base accessory. 1 3/14/12/4 n Tighten the handles securely. Check often to assure the handles remain securely tightened. workpiece 16 Fig. 12