Ryobi P845 Trilingual (P503) - Page 13
Maintenance, Adjustments
View all Ryobi P845 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ADJUSTMENTS WARNING: To prevent accidental starting that could cause serious personal injury, always remove the battery pack from the product when making adjustments. ADJUSTING 0° BEVEL STOP Loosen bevel adjustment knob. Turn setscrew with hex key and adjust base until it is square with the saw blade plate. Tighten bevel adjustment knob securely. 0° BEVEL STOP See Figure 22, page 17. The saw has a 0° bevel stop that has been factory adjusted to assure 0° angle of the saw blade plate when making 90° cuts. CHECKING 0° BEVEL STOP Place the saw in an upside down position on a workbench. Check the squareness of the saw blade plate to the base of the saw using a carpenter's square. WARNING: Attempting a bevel cut without having the bevel adjustment knob securely tightened can result in serious injury. MAINTENANCE WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury. WARNING: To avoid serious personal injury, always remove the battery pack from the product when cleaning or performing any maintenance. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. WARNING: Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury. Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at an Authorized Service Center. 13 - English