Ryobi P845 Trilingual (P503) - Page 8

ASSEMBLY ATTACHING THE BLADE See Figure 2, page 15. WARNING: A 5-1/2 in. blade is the maximum blade capacity of the saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guard, while thicker blades will prevent blade screw from securing blade on spindle. Either of these situations could result in a serious accident.  Remove the battery pack from the saw. n Remove the blade wrench (5 mm hex key) from the stor- age area. n Depress the spindle lock button and remove the blade screw and outer blade washer. NOTE: Turn the blade screw clockwise to remove. CAUTION: To prevent damage to the spindle or spindle lock, always allow motor to come to a complete stop before engaging spindle lock. NOTE: Do not run the circular saw with spindle lock engaged. n Wipe a drop of oil onto the inner blade washer and outer blade washer where they contact the blade. WARNING: If inner blade washer has been removed, replace it before placing blade on spindle. Failure to do so could cause an accident since blade will not tighten properly. n Fit the saw blade inside the lower blade guard and onto the spindle. NOTE: The saw teeth point upward at the front of the saw. n Replace the outer blade washer. n Depress the spindle lock button, then replace the blade screw. Tighten the blade screw securely by turning it counterclockwise. n Return the blade wrench to the storage area. NOTE: Never use a blade that is too thick to allow the outer blade washer to engage with the flats on the spindle. REMOVING THE BLADE See Figure 3, page 15.  Remove the battery pack from the saw. n Remove the blade wrench from the storage area. n Position the saw as shown, depress the spindle lock button, and remove the blade screw by turning it clockwise. n Remove the outer blade washer. n Remove the blade. 8 - English