Samsung CS-29M20SSQ User Manual (user Manual) (ver.1.0) (English) - Page 13

Two: INSTALLATION, Connecting VHF and UHF Antennas, Antennas with 300-ohm Flat Twin Leads

Get Samsung CS-29M20SSQ PDF manuals and user guides View all Samsung CS-29M20SSQ manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

C h aI NpS TtA LeL ArT I OTN w o INSTALLATION Connecting VHF and UHF Antennas If your antenna has a set of leads that look like this, see "Antennas with 300-ohm Flat Twin Leads" below. If your antenna has one lead that looks like this, see "Antennas with 75-ohm Round Leads" on page 14. If you have two antennas, see "Separate VHF and UHF Antennas" on page 14. Antennas with 300-ohm Flat Twin Leads If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300-ohm twin flat leads, follow the directions below. 1 Place the wires from the twin leads under the screws on the 300-75 ohm adapter (not supplied). Use a screwdriver to tighten the screws. 2 Plug the adapter into the "ANT 1 IN (AIR)" terminal on the rear panel. English - 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
English - 13
Connecting VHF and UHF Antennas
If your antenna has a set of leads that look like this,
see “Antennas with 300-ohm Flat Twin Leads”
below.
If your antenna has one lead that looks like this,
see “Antennas with 75-ohm Round Leads” on page
14.
If you have two antennas, see “Separate VHF and
UHF Antennas” on page 14.
Antennas with 300-ohm Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has
300-ohm twin flat leads, follow the directions below.
1
Place the wires from the
twin leads under the screws
on the 300-75 ohm adapter
(not supplied). Use a
screwdriver to tighten the
screws.
2
Plug the adapter into the
“ANT 1 IN (AIR)” terminal on
the rear panel.
I
NSTALLATION
Chapter Two