Samsung DV395ETPARA/A1 User Manual Ver.1.0 (English, French, Spanish) - Page 23
Connecting The Inlet Hose
View all Samsung DV395ETPARA/A1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
01 installing your dryer CONNECTING THE INLET HOSE Method1 - Using the Y Connector and Long Hose The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses. 1. Turn off the cold water faucet. 2. If you have a washer water hose attached to the cold water faucet, unscrew and remove the hose. Y-Connector 3. If space permits, attach the brass female end of the "Y"connector to the cold water faucet. Turn by hand until tight. 4. Attach the straight end of the long hose to the "Y' connector. Screw on the hose coupling by hand until it is tight. Water Hose 5. Using pliers, tighten the hose coupling with an additional two thirds turn. Duct Exhaust Do not overtighten. You can damage the coupling. 6. Attach the angled end of the long hose to the fill valve at the bottom of the dryer's rear frame. Screw on the coupling by hand until it is tight. 7. Using pliers, tighten the hose coupling with an additional two thirds turn. Frame (back) Do not overtighten. You can damage the coupling. Water Hose 8. Attach the water hose to the other side of the "Y" connector. Screw on the hose coupling until it is tight. Using pliers, tighten the coupling with an additional two thirds turn. Do not overtighten. You can damage the coupling. 9. Turn the water faucet on. 10. Check for leaks around "Y" connector, faucets, and hoses. Do not overtighten, as it may damage the coupling. 9. Check that the water faucets are on. 10. Check for leaks around "Y" connector, faucets and hoses. Method2 - Using the Short Hose, Long Hose, and Y Connector The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses. If the "Y" connector cannot be attached directly to the cold water faucet, then you must use the short hose. 1. Turn off the cold water faucet. 2. If you have a washer water hose attached to the cold water faucet, unscrew and remove the hose. 3. Attach the short inlet hose to the cold water faucet. Screw on the coupling by hand until it is tight. Short hose (Inlet to cold water) "Y' connector 4. Using pliers, tighten the coupling with an additional two thirds turn. Do not overtighten. You can damage the coupling. 5. Attach the 'Y" connector to the stainless male end of the small hose. Screw on the coupling by hand until it is tight. 6. Using pliers, tighten the coupling with an additional two thirds turn. Long hose Do not overtighten. You can damage the coupling. 7. Attach the angled end of the long hose to the fill valve at the bottom of the dryer rear frame. Screw on the coupling by hand until it is tight. 8. Using pliers, tighten the coupling with an additional two thirds turn. Do not overtighten. You can damage the coupling. 9. Turn the water faucet on. 10. Check for leaks around "Y" connector, faucets, and hoses. installing your dryer _23 DV405ETPAWR-03021F-03_EN_20120710.indd Sec5:23 2012-07-10 5:30:50