Samsung DVE55M9600V/A3 User Manual - Page 23
Step-by-step installation
View all Samsung DVE55M9600V/A3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Installation Step-by-step installation Make sure you have a qualified technician install the dryer. Step by step installation instructions start below. STEP 1 Install the exhaust system 1. Select a location and move the dryer to the site. For easy access, we recommend you install the dryer in the same location as your washer. 2. To change the door direction, see Door reversal. 3. Install the exhaust system as instructed in the Exhaust ducting guide section. CAUTION Before installing your dryer, remove the packing in the duct. NOTE • To move the dryer easily, lay two of the carton cushions from the packaging on the floor. Tip the dryer on its side so it lies across both cushion-tops. Push the dryer so that it is near its final location, and then set the dryer upright. • Secure room around the dryer to facilitate ducting and wiring. STEP 2 Connect the gas line First, read through the Gas requirements section, and follow these steps. 1. Remove the protective cap from the gas pipe. 2. Apply a LPG (Liquefied Petroleum Gas)-safe compound or 1.5 wraps of Teflon tape to all threaded connections. 3. Connect the gas supply to the dryer. An additional fitting is required to connect the 3/4" (1.9 cm) female thread end of a flexible connector to the 3/8" (1 cm) male threaded end on the dryer. Tighten up the fitting over all threads. 4. Turn on the gas supply, and check for any leaks using a soap solution. If a leak is found, tighten the connections and try again. DO NOT use an open flame to check for gas leaks. FlexDry_DM9600M_DC68-03381H-07_EN.indd 23 English 23 2019-06-03 2:57:17