Samsung MM-ZB7 Instruction Manual - Page 7

Where to Install Your Micro Component System To take full advantage of your new micro component system, follow these installation instructions before connecting the unit. Install the system on a flat, stable surface. Never place this unit on carpeting. Never place this unit in an outdoor area. Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes. Make sure that you have enough room to open the compact disc compartment easily. Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound. Direct the loudspeakers towards the listening area. For optimum performance, make sure that both speakers are placed at an equal distance above the floor. Standby/On Phones TUNER Band CD TAPE AUX Down Rec/Pause Tuning Mode Volume REV.Mode Open/Close Up Demo Sound Mode Inserting Remote Control Batteries GB Insert or replace remote control batteries when you: Purchase the micro component system Find that the remote control is no longer operating correctly When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries. 1 Place your thumb on the position marked on the battery compartment cover (rear of the remote control) and push the cover in the direction of the arrow. 2 Insert two AAA, LR03 or equivalent batteries, taking care to respect the polarities: + on the battery against + in the battery compartment - on the battery against - in the battery compartment 3 Replace the cover by sliding it back until it clicks into position. If you will not be using the remote control for a long time, remove the batteries to prevent corrosion. Push Eject Full Auto Remote Control Operation Connecting your System to the Power Supply The main lead must be plugged into an appropriate socket. Before plugging your system into a main socket, you must check the voltage. 1 Plug the main lead (marked AC Cord on the rear of the system) into an appropriate socket. 2 Press the Standby/On button to switch your micro component system on. 7