Samsung RF217ACBP User Manual (user Manual) (ver.0.1) (English) - Page 10

Setting up your French Door Refrigerator SETTING UP THE REFRIGERATOR Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational. 1. P lace the Refrigerator in an appropriate location with reasonable clearance between it and the wall. Refer to installation instructions in this manual. (page 9, selecting the best location for the Refrigerator) 2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors. 3. S et the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly. 4. A fter powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool. Check the accessories listed below. Compression fitting Compression nut Required Tools (Not provided) Hex Wrench Fastener Phillips screwdriver(+) Flat-blade screwdriver(-) Socket Wrench (10mm) (for bolts) Hex Wrench (3/16") (for Mid hinge) Pliers REMOVING THE REFRIGERATOR DOORS Some installations require door/drawer removal to transport the Refrigerator to its final location. Do not remove the door/drawer if it is not needed. Before removing the door/drawer make sure you read following items. Disconnect power to the Refrigerator before removing the door or drawer. WARNING • B e careful not to drop, damage or scratch the door/drawer while removing them. • B e careful not to get injured while removing the door/drawer. • R eattach the door/drawer properly to avoid: - Moisture from air leakage. - Uneven door alignment. - Wasting energy due to improper door seal. 10_ setting up