Samsung RF266ABPN User Manual (user Manual) (ver.1.0) (English) - Page 9

01 SETTING UP SETTING UP THE REFRIGERATOR Now that you have your new Refrigerator installed and in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational. 1. P lace the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual. 2. O nce the Refrigerator is plugged in, make sure the interior light comes on when you open the doors. 3. S et the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly. 4. A fter powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator once the temperature is sufficiently cool. Water filter (DA29-00003B) Hex wrench (DA80-00002C) Compression Compression fitting nut (DA62-00305A) (DA74-00070B) Fastener (DA60-00143B) Washer (DA80-00002C) Check the accessory list below. Removing the refrigerator doors If your entrance won't allow the Refrigerator to pass easily Tools you will need through it, you can remove the doors. Philips screwdriver 10mm Socket Wrench Allen wrench(3/16") Flat-blade screwdriver Pliers Disassemble the Refrigerator doors 1. W ith the door closed, remove the top table( 1 ) 1 using a Philips screwdriver, and then disconnect the wires( 2 ). Remove hinge screws( 3 ) and ground screw( 4 ) 3 4 2 2. Lift the door straight up to remove. 3. W ith a Philips head screwdriver, remove the two screws( 10 ) attached to the lower left and right door hinges. With an Allen Wrench(3/16"), remove the two hex head bolts( 11 ) attached to the lower left and right door hinges. Remove the lower left and right door hinges( 12 ). 12 10 11 Setting Up _