Samsung SMH1622B Installation Instructions - Page 13

Step-by-step installation guide B. Recirculating (non-vented ductless) B1. Adapting microwave blower for recirculation 2. Lift up the blower plate. 5. Place the blower unit back into the opening. 1. Remove and save screw that holds blower plate to microwave. Back of Microwave NOTE: The exhaust adaptor with damper is not needed for recirculating models. You may want to save them for possible future use. 3. Remove screw holds blower mortor and carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. 6. Secure blower unit to microwave with the screw. B2. Installing the charcoal filter 1. Remove screws on top of grille using a #1 Phillips screwdriver. 2. Open the door. 3. Remove the grille. • After push left, Pull the grille straight off. Charcoal Filter blower mortor screw CAUTION: Do not touch blade of blower for preventing crack and break. Hold outer case when the blower pull out or back into. 4. Roll the blower unit 90 ° so that fan blade openings are facing toward the front of the microwave. Before Roll After Roll 4. Install the charcoal filter. When properly installed, the wire mesh of the filter should be visible from the front. 5. Reinstall the grille and the screws. 6. Close the door. Back of Microwave Back of Microwave Insert mesh-side up 13 SMH8165_XAA DE68-03587A-04-EN_120725.indd 13 2012-07-25 �� 8:05:30