Samsung SP-M220W Owners Manual - Page 17
Replacing and Cleaning the Filter, Ventilation openings, running water.
View all Samsung SP-M220W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Install a new lamp in the reverse order of removal. Replacing and Cleaning the Filter Precautions when replacing the projector filter: • The filter is on the side of the projector. • Turn off the power of the projector, and then disconnect the power cord after the projector has cooled sufficiently. Otherwise, its parts may be damaged due to internal heat. • When you replace the filter, you may release some dust. • For inquiries on replacement filter purchase, please see 'Contact SAMSUNG WORLDWIDE' in Chapter 5. To replace or clean the filter, follow these steps: 1. Turn off the power of the projector, and then disconnect the power cord after the projector has cooled sufficiently. 2. Open the filter cover. 3. Replace or clean the filter. • When cleaning the filter, use a small vacuum cleaner designed for computers and small electronics products, or wash it under running water. • After washing the filter under running water, make sure to dry it completely. The moisture may cause the filter to corrode. • If dust cannot be separated from the filter or the filter is torn, it must be replaced. • After cleaning or replacing the filter, run -> in the menu. Ventilation openings For the location of the ventilation openings, see the picture below: • Do not block the ventilation openings. Blocking the ventilation openings can cause your projector to overheat and may cause it to fail. Air outtake vent Air intake vent Installation and Connection 2-6