Samsung WA48J7770AP/A2 User Manual - Page 17

The water faucets must be within 4 feet Never install your washer on a platform or (122 cm) to the back of your Washer to weakly supported structure. match the inlet hoses provided with your Washer. Location considerations @ NOTE Accessory inlet hoses are available in Do not install your washer in areas where water may freeze, since your washer will always retain some water in its water valve, various lengths up to 10 feet (275 cm) for pump, and hose areas. Frozen water can 5 faucets that are further away from the back damage the belts, the pump, hoses, and ly of your washer. other components. 0) To avoid the possibility of water damage: • Have water faucets easily accessible. Alcove or closet installation • Turn off faucets when the washer is not in use. • Periodically check that there is no Minimum clearances for closet and alcove installations: leakage from the water inlet hose fittings. Sides 1in / Closet 25 mm front 2 in / 51 mm WARNING Check all connections at the water valve and faucet for leaks Rear bin/ 152 mm Top 21 in/ 533 mm If the washer and dryer are installed Drain facility The recommended height of the standpipe is 39 in (99 cm). The drain hose must be routed through the drain hose clip to the together, the closet front must have at least a 72 in2 (465 cm2) unobstructed air opening. Your washer alone does not require a specific air opening. standpipe. The standpipe must be large enough to accept the outside diameter of the drain hose. The drain hose is attached to the washer at the factory. Flooring For best performance, you must install your washer on a solidly constructed floor. Wood floors may need to be reinforced to minimize vibration and/or unbalanced load situations. Carpeting and soft tile surfaces are contributing factors to vibration which can cause your washer to move slightly during the spin cycle. English 17