Samsung WF42H5200AP/A2 User Manual Ver.0 (English, French, Spanish) - Page 16

installing your washer STEP 3 Installing your Washer 1. If you use a standpipe, make sure the connection between the drain hose and the standpipe is NOT airtight. The standpipe must be at least 18 in or 46 cm high. You must always exercise caution to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way - by elbows, couplings, or excessive length. For situations where the drain hose cannot 96" Max 18" Min be conveniently elevated to at least 18 in or 46 cm, the drain hose must be supported. If drain hose is installed below 18"(46cm), water can be drained in cycle working cause of siphon phenomenon. It causes the washer to "nF" error. Laundry tub Standpipe Hose retainer Tie strap 96" Max 18" Min Drain Hose can be installed until 96"(245cm) maximum. But drain capability can be reduced at this height. It causes the washer to have an odor because of remaining water in the drain system. 1RPRUHWKDQ ರFP Connect the hose guide within 6"(15cm) from the end of the drain hose. If the drain hose is extended more than 6"(15cm) beyond the end of the hose guide, mold or microorganisms could spread to the inside of the washer. +RVH*XLGH Cold Hot 2. Check the inlet hose to ensure a washer is inside each fill hose. Thread the inlet hoses to the HOT and COLD faucet connections. On the other end of the hose, check for one rubber washer per hose Rubber Washer and attach each fill hose to the water valve. Make sure the hose with Hot printed on it is attached to the HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers. For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an "nF" (no fill) error can occur. Cold printed Hot printed 3. Turn on the "HOT" and "COLD "water supply and check the water valve and the water supply connections for leaks. #&55&3@8 JOEE


 16_English