Sanyo MPR-1013R Instruction Manual - Page 13
Installation
View all Sanyo MPR-1013R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
INSTALLATION Installation 1. Remove the packaging materials and tapes Remove all transportation packaging materials and tapes. Open the doors and ventilate the unit. If the outside panels are dirty, clean them with a neutral detergent and wipe it off with a soft cloth washed in clean water. 2. Adjust the leveling foot Extend the leveling feet by rotating them counterclockwise until they make contact with the floor. See Fig. 1. Ensure the unit is level. Leveling foot Fig. 1 3. Fix the unit Two fixtures are attached to the rear of the frame. Fix the frame to the wall by attaching a rope or chain between the wall and the fixtures. 1) Reattach the fixtures as shown in Fig. 2. 2) If holes can be drilled in the wall, drill a 10.5mm diameter hole and fix the unit by using the special bolt-nut supplied. This bolt-nut can only be used on a concrete wall. See Fig. 3. 4. Ground (earth) Bolt (provided) Fig. 2 45 mm 10.5 mm Fig. 3 WARNING Use a power supply outlet with ground (earth) to prevent electric shock. If the power supply outlet is not grounded, it will be necessary to install a ground by qualified engineers. Never ground the unit through a gas pipe, water main, telephone line or lightning rod. Such grounding may cause electric shock in the case of an incomplete circuit. 12