Sanyo MPR-1013R Instruction Manual - Page 23

ROUTINE MAINTENANCE Replacement of fluorescent lamp 1. The fluorescent lamp is placed vertically at the center of the frame (MPR1013 and MPR-1013R) and horizontally at the top front of the cabinet (MPR-513 and MPR-513R) 2. Turn off the fluorescent lamp switch and disconnect the power supply plug . 3. For MPR-513 and MPR-513R, remove the top shelf, for MPR-1013 and MPR-1013R, remove all shelves in the left side of the cabinet. 4. As shown in Fig. 1 and Fig. 2, pull the fluorescent lamp towards the rear together with the cover and wiring. 5. Take out the fluorescent lamp and remove the connector water-proofing rubber at both ends. As shown in Fig. 3, shift the rubber by rolling it. 6. Pull out the fluorescent lamp. Pull gently from the cover. 7. After replacing a new fluorescent lamp, return it to the original position. Recommended fluorescent lamp: MPR-513, MPR-513R: FL20SD MPR-1013, MPR-1013R: FL40SD Replacement of glow starter MPR-1013 MPR-1013R Fig. 1 MPR-513 MPR-513R Fig. 2 Fig. 3 The glow starter is located on the right side of top front for MPR-513 and MPR-513R, and center of top front for MPR-1013 and MPR-1013R in the chamber. 1. Turn off the fluorescent lamp and then disconnect the power supply cord of the refrigerator. glow starter 2. Remove the water-proof cover and take out the glow starter. 3. Attach a new lamp surely. The starter designation is as follows: MPR-513, MPR-513R: FG-1P MPR-1013, MPR-1013R: FG-4P cover 4. Replace the water-proof cover on the glow starter. 22