Sanyo PLC-XF47 Owners Manual - Page 63
Forget the Logo PIN code, The Remote Control does
UPC - 086483068959
View all Sanyo PLC-XF47 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Appendix Picture is not bright enough. - Check if "Contrast" or "Brightness" are adjusted properly. (See page 44) - Check if "Image level" is selected properly. (See pages 37, 41) - Check the Lamp control function. ( See "SETTING" section on page 50) - Check the Lamp replace indicator. If it lights, the end of lamp life is approaching. Replace the lamp with a new one promptly. (See page 57) - T he image is darker when 2 lamp mode is selected, compared with 4 lamp mode. Check the lamp mode at SETTING section on page 50. The color is strange. The image is distorted or runs off. - Check the Input signal, color system, video system, or computer system mode. - Check "PC Adjust" menu or " Screen" menu and adjust them. Auto PC adjustment function does not work. - C heck the Input signal. Auto PC Adjustment function can not work when 480p, 575p, 720p, 480i, 575i, 1035i, or 1080i is selected or when the digital signal is input into DVI terminal. (See page 34) The setting does not remain after turning off power. - M ake sure you selected "Store" after adjusting settings. Some settings can not be stored if not registered with "Store". Power management - P ower management function can not work while "Freeze" or "No Show" function is function does not work. running. Capture work. function does not - Check the connection to see if there is signal. Some menus can not be selected. - Each of the Video Input and Computer Input has a limit on selectable menus. The power is turned off automatically. - P ower management function runs by initial setting. Check "SETTING" section on page 51. You can not operate with - T he side control is not available If the side control is locked at "Key lock" under "Security" the side control. of SETTING section. Please check "SETTING" section on page 52. Indicators blinks or lights. - C heck the status of the projector with referring to " INDICATORS AND PROJECTOR CONDITION" on pages 68-69. - Check the batteries. - Check if the RC sensor is set properly.(See page 51) - Make sure no obstruction is between the projector and remote control. - Make sure you are not too far from a projector when using the remote control. Maximum operating range is 16.4' (5m). The Remote Control does - Make sure that the remote control code conforms to the projector's code. not work. (See "SETTING" section on page 50.) - M ake sure the reset switch in the compartment lid on back of the remote control is set to use position. - Unlock the Key lock function for the remote control. (See page 52) - W ireless remote control does not work when the remote control cable is connected to the projector. (See page 15) Unable to unlock the Logo PIN code lock, Security key lock or Security PIN -Contact the dealer where you purchased the projector or the service center. code lock. Forget the Logo PIN code or Security PIN code. -Contact the dealer where you purchased the projector or the service center. appears on the screen - Your operation is invalid. Operate correctly. 63