Sanyo PLC-XU07N Owners Manual - Page 10

CONNECTING THE PROJECTOR TERMINALS OF THE PROJECTOR COMPUTER INPUT TERMINAL Connect the computer output to this terminal. (Refer to P12 ~15.) MONITOR OUTPUT TERMINAL Connect to the monitor to this terminal. (Refer to P12 ~15.) CONTROL PORT CONNECTOR When controlling the computer with the Remote Control of this projector, connect the mouse port to this connector. (Refer to P12 ~15.) COMPUTER IN MONITOR OUT CONTROL PORT AUDIO IN SERIAL AUDIO OUT COMPUTER AUDIO INPUT JACK Connect the audio output from the computer to this jack. (Refer to P12 ~15.) R-AUDIO-L VIDEO (MONO) ˝S-VIDEO AUDIO INPUT JACKS Connect the audio outputs from the video equipment to these jacks. (Refer to P11.) q When the audio output is monaural, connect it to the AUDIO LEFT jack. VIDEO INPUT JACK Connect the video output from the video equipment to this jack. (Refer to P11.) S-VIDEO INPUT JACK Connect the S-VIDEO output from the video equipment to this jack. (Refer to P11.) SERIAL PORT CONNECTOR This connector is used to connect a computer to control this projector with the PC. (Refer to P12 ~13.) AUDIO OUTPUT JACK Connect the audio amplifier to this jack. (Refer to P12 ~15.) RESET BUTTON This projector uses a micro processor to control the unit. Occasionally, the micro processor may malfunction and need to be reset. This can be done by pressing the RESET button with a pen, which will shut down the unit. Turn the projector off and restart the unit. Do not use the RESET function excessively. COMPUTER INPUT / MONITOR OUTPUT TERMINAL Terminal : HDB15-PIN Connect the display output terminal of the computer to this COMPUTER INPUT with the VGA Cable (supplied), and connect the monitor to this MONITOR OUTPUT with the monitor cable (not supplied). When connecting the Macintosh computer, the MAC/VGA Adapter is required (not supplied). Pin Configuration 54 32 1 10 9 8 7 6 15 14 13 12 11 CONTROL PORT CONNECTOR Terminal : MULTI-POLE 12-PIN When controlling the computer with the projector's Wireless Remote Control Unit, connect control port (PS/2, Serial or ADB port) on your computer to this connector. (Control Cable for PS/2 Port is supplied.) Pin Configuration 21 6 54 3 10 9 8 7 12 11 SERIAL PORT CONNECTOR Terminal : DIN 8-PIN This connector is used to connect a computer to control the projector with the PC. For this connection, the Serial Cable is required (This cable is not supplied). Pin Configuration 876 5 43 21 10 1 Red Input 9 Non Connect 2 Green Input 10 Ground (Vert.sync.) 3 Blue Input 11 Sense 0 4 Sense 2 12 Sense 1 5 Ground (Horiz.sync.) 13 Horiz. sync. 6 Ground (Red) 14 Vert. sync. 7 Ground (Green) 15 Reserved 8 Ground (Blue) PS/2 1 ----2 CLK 3 DATA 4 ----5 ----6 ----7 ----8 ----9 GND 10 ----11 ----12 ----- Serial T X D R X D ----- READY ----- GND ADB ----- ADB GND 1 R x D 5 MUXTTL 2 ADB 6 T x D 3 MUX232 7 ----- 4 GND 8 -----