Sanyo PLC-XU07N Owners Manual - Page 35
APPENDIX, LAMP REPLACEMENT Indicator, Lamp Replacement Monitor Timer, LAMP REPLACEMENT - bulb
View all Sanyo PLC-XU07N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
APPENDIX LAMP REPLACEMENT Indicator When the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights yellow. When the image become dark or the color of the image become unnatural, replacement of the Lamp is required. LAMP REPLACEMENT CAUTION q For continued safety, replace with a lamp assembly of the same type. q Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot. q Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury. Follow these steps to replace the lamp assembly. 1 Turn off the projector and disconnect the AC plug. Allow the projector to cool for at least 45 minutes. 2 Remove a screw with a screwdriver and remove the lamp cover. 3 Remove 2 screws with a screwdriver and pull out the lamp assembly by grasping the handle. LAMP COVER 4 Replace the Lamp Assembly and tighten 2 screws. Make sure that the Lamp Assembly is set properly. And replace the Lamp Cover and tighten a screw. 5 Connect the AC Power Cord to the projector and turn the projector on. 6 Reset the Lamp Replacement Monitor Timer (refer to the section "Lamp Replacement Monitor Timer" below.) NOTE : Do not reset the LAMP REPLACEMENT HANDLE MONITOR TIMER, when the lamp is not replaced. LAMP ASSEMBLY ORDER REPLACEMENT LAMP Replacement Lamp can be ordered through your dealer. information to the dealer. q Model No. of your projector : PLC-XU07N q Replacement Lamp Type No. : POA-LMP19J (Service Parts No. 610 278 3896) When ordering the Lamp, give the following Lamp Replacement Monitor Timer Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the Lamp Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops to lighting. 1 Turn the projector on, and press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select SETTING and press the SELECT button (refer to the page 32). Another dialog box SETTING MENU Menu will appear. 2 Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to Lamp age, and then press the SELECT button. The message of "Lamp replace monitor Reset?" is displayed. 3 Select [Yes] to reset the Timer. Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced. 35