Sanyo PLC-XU07N Owners Manual - Page 17

BEFORE OPERATION, Remote Control Batteries Installation, Operating Range of the Remote Control

Get Sanyo PLC-XU07N - XGA LCD Projector PDF manuals and user guides View all Sanyo PLC-XU07N manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

BEFORE OPERATION Remote Control Batteries Installation 1 Remove the battery compartment lid. Press the lid downward and slide it. 2 Slide the batteries into the compartment. 3 Replace the compartment lid. For correct polarity (+ and -), be sure the battery terminals are in contact with the pins in the compartment. Slide the lid upward. To insure safe operation, please observe the following precautions : q Use (2) AA type alkaline batteries. q Replace two batteries at the same time. q Do not use a new battery with a used battery. q Avoid contact with water or liquid. q Do not drop the remote control unit. q If batteries have leaked on the remote control, carefully wipe the case clean and load new batteries. Operating Range of the Remote Control Point the remote control toward the projector (Receiver Window) whenever pressing the buttons. Maximum operating range for the remote control is about 16.4' (5m) and 60° front and rear of the projector FRONT REAR 16.4' (5 m) 60° 16.4' (5 m) 60° 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
17
BEFORE OPERATION
Remote Control Batteries Installation
1
2
3
Slide the lid
upward.
Press the lid
downward and
slide it.
For correct polarity (+ and –), be sure
the battery terminals are in contact
with the pins in the compartment.
Remove the battery
compartment lid.
Slide the batteries into
the compartment.
Replace the compartment
lid.
Operating Range of the Remote Control
To insure safe operation, please observe the following precautions :
●
Use (2) AA type alkaline batteries.
●
Replace two batteries at the same time.
●
Do not use a new battery with a used battery.
●
Avoid contact with water or liquid.
●
Do not drop the remote control unit.
●
If batteries have leaked on the remote control, carefully wipe the case clean and load new batteries.
Point the remote control toward the projector (Receiver Window) whenever pressing the buttons.
Maximum
operating range for the remote control is about 16.4’ (5m) and 60° front and rear of the projector
16.4'
(5 m)
60°
16.4'
(5 m)
60°
FRONT
REAR