Sanyo PLC-XU355 Instruction Manual, PLC-XU355A - Page 67
Auto PC adjustment function does, The setting does not remain after
UPC - 086483073847
View all Sanyo PLC-XU355 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Appendix No image - Check the connection between your computer or video equipment and the projector. See pages 16-18. - See if the input signal is correctly output from your computer. Some laptop computers may need to change the setting for monitor output when connecting to a projector. See your computer's instruction manual for the setting. - It takes about 30 seconds to display an image after turning on the projector. See page 20. - Check the Input signal, color system, video system or computer system mode. - Make sure the temperature is not out of the specified Operating Temperature (41˚F-95˚F [5˚C-35˚C]). - When No Show function is operating, the image cannot be displayed. Press the NO SHOW button or any other button on the remote control. No sound - Check the audio cable connection from audio input source. - Adjust the audio source. - Press the Volume + button. See page 26. - Press the Mute button. See page 26 - When the AUDIO OUT is plugged-in, the projector's built-in speaker is not available. - Is the image projected? You will hear the sound only when the image is projected. The color is strange. - Check the Input signal, color system,video system or computer system mode. - Make sure Blackboard is not selected on Image select menu. See pages 35,42. Some displays are not seen during the operation. - Check the Display function. See page 48. Auto PC adjustment function does not work. - Check the Input signal. Auto PC adj.function can not work when 480p,575p.720p,480i,575i,1035i or 1080i is selected or when the digital signal is input into DVI terminal. See page 32 The setting does not remain after turning off power. - Make sure you selected Store after adjusting setting. Some settings can not be stored if not registered with Store. See page 37,44. - Power management function can not work while Freeze or No Po wer management d oes not work. Show function is running. See page 53. Capture function does not work. - Check the connection and the input signal to see if there is signal. - Make sure Off is not selected at any function of "Auto setup A u t o s e t u p d o e s n o t w o r k p r o p e r l y . See page 47 Make sure On is not selected at the Ceiling function. See page 52. Auto keystone function does not work even when the projector is tipped. - Make sure the Auto keystone function is not set to Manual. Press the AUTO SET UP button on the top control. See pages 25,47. 67