Sanyo WXU300 Instruction Manual, PLC-WXU300 Network Operation - Page 12
Connecting to the LAN line, Network configuration, Setting Procedure
UPC - 086483074226
View all Sanyo WXU300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Chapter 2 Setup Procedures Setting procedures and contents differ depending on the LAN installation location. When installing, consult your system administrator to set up the LAN appropriately. Connecting to the LAN line Connect the LAN cable to the LAN connection terminal of the projector. LAN Connection Terminal ACT Lamp (Orange) Blink orange when the projector is sending or receiving the data. LAN Cable LINK Lamp (Green) Light green when the projector is connected to the network correctly. Network configuration Set the Wired LAN network through the projector menu. Detailed network settings will be made with browser. Refer to "3. Basic setting and operation" (p.17-30). First, complete the settings described in this chapter before performing steps in "3. Basic setting and operation." Setting Procedure 1. Select "LAN mode select" in the Network menu, and press Point 8 or SELECT button. 2. Select similar LAN environment among LAN1, LAN2 and LAN3 with the Point ed but- tons. Then the Menu will disappear, the "Please wait..." message will appear, and switching operation will start. Switching will take a while and the projector's LINK/ACT Lamp will be on or blink, and after completing the operation, the "Please wait..." message will disappear. 12