Sanyo WXU300 Instruction Manual, PLC-WXU300 Network Operation - Page 9
Flow of installation, Notice about installing Software CD-ROM
UPC - 086483074226
View all Sanyo WXU300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Flow of installation Flow of installation To use the projector via the networks, follow the setup procedures below. STEP 1 Connect the LAN and set the configuration. Decide depending on the LAN environment. ➔ "2. Setup Procedures" (pp.11-16). Detailed LAN configurations need to be done with a browser later. First, complete the Wired LAN connection between computers and projectors, then start browser configurations. ➔ "3. Basic setting and operation" (pp.17-30). STEP 2 Network Configuration has completed. Follow each chapter to operate the projector. ■ Operate and manage the projector ➔ "4. Controlling the projector" (pp.31-42) ➔ "Power Control and status check" (p.32) ➔ "Control" (p.34) ➔ "PC adjustment" (p.38) ➔ "Setting up the projector" (p.39) ➔ "Projector information" (p.42) STEP 3 Install the Software on computers. Install the software recorded in CD-ROM on each computer which will be operated. Refer to the owner's manual of PJ Network Manager. Notice about installing Software CD-ROM It is available for controlling and setting of the projector by using the web browser without installing any software. So it is not required to install the software into your computer. For PJ Network Manager function, it is required to install the software. Please see the owner's manual of "PJ Network Manager Function". ENGLISH