Sanyo WXU300 Instruction Manual, PLC-WXU300 Network Operation - Page 33

About projector condition Power control and status check Status Description Normal Projector is operating normally. Power management in operation........... Power management is operating Lamp failure Lamp failure is occurring Abnormal Temperature The temperature of the projector became too high Standby after Abnormal Temp......... Projector detects abnormal temp. and sets into standby mode. Power failure Power failure has occurred inside the projector. Projector is turned off. Unplug the AC cord and ask servicing to a qualified service personnel.  When a security (PIN code lock) has been set on the projector, you also cannot control it through the network. To control the projector through the network, unlock the security on the projector using with the projector's menu control. Caution about turning on/off the projector via the networks When turning on/off the projector via the networks, preset the projector as follows: 1. Select "Setting" from the Projector menu. 2. Select "Standby mode" from the Setting menu and set it as "Network". If you set this function as Network, the network part of the projector is constantly provided with power even if the projector is turned off. If you set this as Eco, then the network part will be turned off when you turn off the projector. Consequently, you cannot turn on/off the projector via the networks. 33 ENGLISH