Sanyo mpr-214f Instruction Manual - Page 24
Installation Of Temperature Recorder
View all Sanyo mpr-214f manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
INSTALLATION OF TEMPERATURE RECORDER Installation of recorder MTR-0620LH (1) 1. Attach the fixture to the temperature recorder (MTR-0620LH) by referring to the instruction manual enclosed with the recorder. (Fig. 1) 2. Remove 2 (outside) of 4 screws on the front left of the top panel. Fix the recorder to the top panel by using the 2 screws as shown in Fig. 2. Fig. 1 Fig. 2 3. Remove the caps (both outside and inside) covering the access port for refrigerator and take out the thermal insulation in the port. Pass the recorder sensor to the chamber through the port. Then replace the thermal insulation and caps (both outside and inside). (Fig.3) Note: Make a cut on the caps for access port to pass the capillary tube as shown in the figure below. Fig. 3 4. Fix the recorder sensor to the attachment hole on the back side of the refrigerator by using the large clips provided as an accessory. (Fig. 4) 5. Arrange the capillary tube so that it cannot contact the shelf. Care should be taken for the following points to avoid the crush of the tube when bending the capillary tube. ɾDo not bend the tube of 30 mm from the edge of the sensor. Clip ɾDo not bend and extend the tube repeatedly at the same point. ɾThe bending should be R10ʙR15. Fig. 4 23