Sanyo mpr-214f Instruction Manual - Page 30
Make a cut on the caps for access port
View all Sanyo mpr-214f manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
INSTALLATION OF TEMPERATURE RECORDER 5. Remove the caps (both outside and inside) covering the access port for refrigerator and freezer and take out the thermal insulation in the port. Pass the recorder sensor to the chamber through each port. Then replace the thermal insulation and caps (both outside and inside). Replace the cap on the port for taking out the recorder sensor. (Fig.18) Note: The identification label is adhered to the lead wire to distinguish between the sensor for refrigerator and for freezer. Note: Make a cut on the caps for access port to pass the lead wire as shown in the figure below. Fig. 18 6. Fix the recorder sensor to the attachment hole on the back side of the refrigerator by using the clips enclosed with the recorder fitting (MPR-S7: optional component). (Fig. 9) Clip Fig. 19 7. Fix the recorder sensor to the attachment hole on the left side of the freezer by using the clips enclosed with the recorder fitting (MPR-S7: optional component). (Fig. 20) Fig. 20 29