Schwinn 150 Upright Bike Assembly and Owner's Manual - Page 43

Unit operates but Telemet- Chest Strap ric (if equipped) HR not displayed Interference Replace Chest Strap Replace Console Console displays "E2" error Check data cable integrity code Check data cable connections/orientation Console Electronics No speed/RPM reading, Console displays "Please Pedal" error code Check data cable integrity Check data cable connections/orientation Check magnet position (requires shroud removal) Check Speed Sensor (requires shroud removal) Strap should be "POLAR®" compatible and uncoded. Make sure strap is directly against skin and contact area is wet. Try moving unit away from sources of interference (TV, Microwave, etc). If interference is eliminated and HR does not function, replace strap. If HR still does not function, replace Console. All wires in cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. If tests reveal no other issues, Console should be replaced. All wires in cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Magnet should be in place on pulley. Speed sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. 43