Sharp 20F640 User Manual - Page 43

Operation of Remote Control (Continued) TV POWER REMOTE KEYPAD POWER (DVD/VCR) POWER CATV TV DVD VCR DISPLAY INPUT 123 456 78 FLASHBACK 0 9 ENTER 100 PERSONAL PREFERENCE A BCD CH 8 VOL - ; 9 CH MENU MUTE : VOL + g SKIP f POWER (DVD/VCR) 9 VCR-CH 8 PLAY : REC REW ( L STOP FWD ) PAUSE J TV • CATV • VCR • DVD CATV/DVD-TV/VCR INPUT DISPLAY CHANNEL UP (,)/ DOWN(9) L HOW TO IDENTIFY A DVD The remote control may already be set to operate your DVD. Try this initial check before going on to the following "identify" section. (1) Press CATV/DVD button. (2) Point remote towards DVD and press POWER (DVD/VCR). (3) Does the remote turn the DVD ON and OFF? • If yes, the remote is ready to operate the DVD and no further steps are needed. • If no, continue to the "identify" section. L To identify your DVD - Direct Entry Method. Use the following steps and list to quickly find the remote control code for your accessory DVD. • First look up your DVD's remote control code number before going through the direct code entry steps control. (1) Press CATV/DVD button. (2) Press and hold down INPUT and CH s on your remote control. Then release both buttons. (3) Within ten seconds after releasing INPUT and CH s, enter your DVDs two-digit remote control code number using REMOTE KEYPAD (refer to list). • The remote control is now ready to send commands to your DVD. DVD BRAND Denon JVC Magnavox Marantz Mitsubishi Panasonic Philips Pioneer Proscan RCA Samsung Sharp Sony Toshiba Yamaha Zenith REMOTE CONTROL CODE NUMBER 02 09 04 04 06 02 04 08 03 03 07 01, 10 05 04 02 04 Note: Depending on the model, year produced, brand, and type of DVD, some models may not be compatible with the remote control. 43