Sharp AL-1250 AL-1220 AL-1250 Operation Manual - Page 35
Copier Trouble? - copier al
UPC - 074000072374
View all Sharp AL-1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
6 COPIER TROUBLE? This chapter describes misfeed removal and troubleshooting. MISFEED REMOVAL When the misfeed ( ) indicator blinks or blinks in the display, the copier will stop because of a misfeed. If a misfeed occurs when using the SPF, a number may appear in the display after a minus sign. This indicates the number of the originals that must be returned to the document feeder tray after a misfeed. Return the required number of originals. Then this number will disappear when copying is resumed or the clear ( ) key is pressed. When the SPF misfeeds an original sheet, the copier will stop and the SPF misfeed ( ) indicator will blink, while the misfeed ( ) indicator will remain off. For a misfeed of originals in the SPF, see "E Misfeed in the SPF" on page 38. If the AL-1250 and AL-1521 are turned on with the lower side cover open, the misfeed ( ) indicator will blink. In this case, close the lower side cover. The misfeed ( ) indicator will go out. 6 1 Ensure that the bypass tray is open and then open the side cover while pressing the side cover open button. Copier trouble? 2 Check the misfeed location. Remove the misfed paper following the instructions for each location in the illustration below. If blinks in the display, proceed to "A Misfeed in the paper feed area". (p. 35) If paper is misfed here, proceed to "B Misfeed in the fusing area". (p. 35) If the misfed paper is seen from this side, proceed to "C Misfeed in the transport area". (p. 36) 34 If paper is misfed here, proceed to "A Misfeed in the paper feed area". (p. 35) If paper is misfed here, proceed to "D Misfeed in the lower paper feed area". (p. 37) (AL-1250/AL-1521 only)