Sharp BT421 User Manual for the - Page 17

English Power Indicator LED indicator status and lighting pattern Glowing green Glowing red Condition Recovery Normal The monitor is turned off with the scheduler function set. Turn off the monitor by the remote control or the monitor button. 1. Turn on the monitor by the remote control or the monitor button. 2. Send an AV signal input to the monitor. Turn on the monitor by the remote control or the monitor button. NOTE: If the indicator is blinking red, a certain failure might have occurred, please contact your supplier. Aspect Full Trim up Trim down Zoom Normal Mode Full Original Signal 16:9 4:3 Trim up Using Power Management This LCD monitor follows the VESA approved DPM (Display Power Management) function. The power management function is an energy saving function that automatically reduces the power consumption of the monitor when the keyboard or the mouse has not been used for a fixed period. This allows your LCD monitor to enter a Power Management mode if the monitor's POWER SAVE function is set to ENABLE, and a certain amount of time has passed since the monitor recognized "no signal input". It will increase the life and decrease the power consumption of the monitor. NOTE: Depending on the computer and display card used, this function may not operate. After the video signal was lost, the monitor automatically goes into OFF at a preset time period. Trim down Zoom Normal *3 Grey areas indicate unused portions of the screen. FULL: Fills the entire screen. Trim Up: Expands the image horizontally to fill the entire screen while maintaining the aspect ratio. A strip 80 pixels thick is cut from the top of the screen. Trim Down: Expands the image horizontally to fill the entire screen while maintaining the aspect ratio. A strip 80 pixels thick is cut from the bottom of the screen. ZOOM Expands/reduces the image size horizontally or vertically to the respective magnification ratios. (The image can be expanded from 0.9 to 3 times both horizontally and vertically.) The display position can be adjusted with H.Position and V.Position respectively. NORMAL: Reproduces the aspect ratio that is sent from the source. Information OSD The Information OSD provides information such as: Input Source, Input Resolution, etc. Press the INFO button on the remote to bring up the Information OSD. English-15