Sharp ER-A330 Programmer Manual - Page 28

CHAPTER 3. OP X/Z, X1/Z1,X2/Z2 MODE The following categories of reports can be printed by the ECR. 1) OP X/Z reports (individual clerk reports) 2) X1/Z1 reports (Daily sales total X and Z reports) 3) X2/Z2 reports (Periodic total X and Z reports) 1. Print report . In the table below those reports marked with a circle " " can be printed by the standard machine and those marked with an asterisk "*" can be printed when the corresponding option is added. REPORT NAME KEY ENTRY GENERAL DEPT/GROUP TRANSACTION HOURLY DAILY NET PLU (RANGE) PLU (DEPT) CASHIER (IND) CASHIER (IND) CASHIER (ALL) TL/NS CR1 CH1 #/TM/ST #/TM/ST PLU DPTn DPT# CSR# CH2 RA OP X/Z X Z . . . . MODE X1/Z1 X1 Z1 .. . . .. .. . .. .. .. X2/Z2 X2 Z2 . . . . . . . . . DATA FOR READING GROUP CODE PLU CODE DEPT. CODE (IN CODE ENTRY SYSTEM) CASHIER CODE (in X1/Z1) REMARK *1 *1, *2 *1 *1 *1 *1, *3 *1, *5 *1 *1, *4, *6 *1 *1 To read respective reports, it is necessary to follow the procedure below. Reading (X report) Reading (Z report) KEY *2 All X CR1 Group code (1 to 9) *3 PLU code range can be specified by entering the start and end numbers according to the following procedure. When specifying a single time interval, PLU code, the start number has only to be entered. All XXX X PLU code Single XXX End No. R ea d ing PLU *4 To read respective reports, it is necessary to follow the procedure below. OP/XZ X Chshier code Reading Res etting CASH# *5 To read respective reports, it is necessary to follow the procedure below. XX Dept. code DEPT# *6 In OP X/Z mode, [CH2] key is available instead of [CSR#] key, in case of SRV#910: CASHIER SYSTEM = 1 hole key and SRV#950: [CSR#] key does not exist in the key layout. - 27 -