Sharp ER-A330 Programmer Manual - Page 29
Flash report, Overflow mark
View all Sharp ER-A330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
2. Flash report REPORT NAME KEY ENTRY NET3 DEPT DEPT/GROUP HOURLY CID TL/NS DPTn DPT# CR1 #/TM/ST ⊗ OP X/Z X Z . . . . . MODE X1/Z1 X1 Z1 *3 X2/Z2 X2 Z2 *3 DATA FOR READING REMARK *9 DEPT. CODE GROUP CODE *7 TIME *8 *7 To read respective reports, it is necessary to follow the procedure below. Group No. CR1 *8 To read respective reports, it is necessary to follow the procedure below. TIME #/TM/ST TIME : 24 hour system (2 digits) *9 XX Dept. code DEPT# 3. Overflow mark If the amount in any totalizer other than GT to be printed on X or Z reports exceeds a programmed limit, the indication mark (overflow mark) is printed for the totalizer concerned. The overflow mark may be printed even if a totalizer does not reach the maximum amount. This occurs, for example, when the amount in the totalizer gets smaller than the maximum amount due to the entry of a negative amount after the overflowing of the totalizer. This means that when the totalizer overflows once, the overflow mark (for example, "555") is printed. Samples of respective reports are shown on the following pages. - 28 -