Sharp KB-3300JW KB-3000JS , KB-3300JK , KB-3300JW Operation Manual - Page 27

• Do not use the razor blade for daily cleaning as it may wear the pattern on the glass. METAL MARKS OR BURNED ON RESIDUE Metal marks and burned on residue should be removed immediately after the cooktop has cooled. Metal marks can become permanent if not removed prior to future use. 1 Dampen a "scratchless" or "never scratch" pad that is safe for non-stick cookware. The pattern and glass will be damaged if the pad is not damp or is soiled or if another type of pad is used. Apply a cleaner cream for glass ceramic cooktops. 2 Scrub to remove as much soil as possible. 3 Apply the cleaner cream over the soil, cover with a damp paper towel and let stand 30 minutes to 1 hour. Keep moist by covering the paper towel with plastic wrap. 4 Scrub again and wipe off with another clean, damp paper towel. Then wipe dry. Note: • Do not use aluminum foil on the cooktop. • If pots or pans of aluminum or copper are allowed to boil dry, permanent damage may affect the ceramic glass surface. • Do not slide pots and pans across the cooktop surface. • Cookware with rough bottoms can mark or scratch the cooktop surface. • Do not use a dull or nicked blade. Be sure to use a new, sharp razor scraper. MICROWAVE DRAWER INTERIOR Cleaning is easy because no heat is generated to the interior surfaces; therefore, there is no baking and setting of spills or spattering. To clean the interior surfaces, including drawer sealing surfaces, wipe with a soft damp cloth. DO NOT USE ABRASIVE OR HARSH CLEANERS OR SCOURING PADS. For heavier soil, use mild soap; wipe clean with a soft damp cloth. Do not use any chemical oven cleaners. MICROWAVE DRAWER GUIDES Remove the food crumbs from the Microwave Drawer guides. Wipe with a soft dry cloth in order to keep the Microwave Drawer opening and closing easily. WAVEGUIDE COVER ATTENTION The waveguide cover (located on the inside top of the microwave drawer area) is made from mica, so it requires special care. Keep the waveguide cover clean to assure good microwave performance. Carefully wipe with a soft damp cloth any food spatters from the surface of the cover immediately after they occur. Built-up splashes may overheat and cause smoke or possibly catch fire. Do not remove the waveguide cover. CLEANING AND CARE ODOR REMOVAL Occasionally, a cooking odor may remain in the Microwave Drawer. To remove, combine 1 cup water, grated peel and juice of one lemon and several whole cloves in a 2-cup glass measuring cup. Boil for several minutes using 100% power. Allow to set in the Microwave Drawer until cool. Wipe interior with a soft cloth. OVEN CAUTION Before cleaning any part of the oven, be sure the oven is turned off. If not, press Stop/Clear. Allow the oven to cool before cleaning. INSIDE OF THE DOOR You do not need to clean the area inside the gasket by hand since the area is cleaned during the self-clean cycle. Do not rub, clean or move the door gasket. Replace gasket when it is worn or frayed. The area outside the gasket and the door liner can be cleaned with a soap-filled steel wool or plastic pad, hot water and detergent. Rinse well with a vinegar and water solution. INSIDE OF THE OVEN (SELF-CLEANING) See page 24. REMOVE AND REPLACE OVEN DOOR 1 Open the door to the fully opened position. 2 Pull the lock located on both hinge supports up and engage in the hook of the hinge levers. You may have to apply a little downward pressure on the door to pull the locks fully over the hooks. 3 Grab the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports. Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disengage the hinge levers. 4 Proceed in reverse to reinstall the door. Make sure the hinge supports are fully engaged before unlocking the hinge levers. CAUTION The door is very heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down. Lock in normal position. 27