Sharp KB4425LS KB-4425LS , KB-4425LK , KB-4425LW Installation Instructions - Page 3

Important notes to the installer • Read all of the Installation Manual before installing the range. • Remove all packing material from the oven and drawer before connecting the electrical supply to the range. • Observe all governing codes and ordinances. • Be sure to leave these instructions with the consumer. Important notes to the consumer Keep this manual with your Operation Manual for future reference. • As when using any range generating heat, there are certain safety precautions you should follow. These are listed in the Operation Manual. Read all and follow carefully. • Be sure your range is installed and grounded properly by a qualified installer or service technician. Unpacking and Examining your Range 1 Remove all packing materials from inside the Microwave Drawer Sealing Surface and the oven cavity. Waveguide DO NOT REMOVE Cover THE WAVEGUIDE COVER, which is located on the top of the Microwave Drawer. 2 Remove the feature Sealing Surface sticker, if there is one. Check the drawer for Microwave Drawer Cavity any damage, such as misaligned or bent drawer, damaged drawer seals and sealing surfaces, broken or loose drawer guides and dents inside the drawer or on the front side of the drawer. If there is any damage, do not operate the Microwave Drawer and contact your dealer or a SHARP AUTHORIZED SERVICER. Important Safety Instructions If the information in this manual is not followed exactly, a fire or electrical shock may result causing property damage, personal injury or death. • All Ranges can tip • Injury to persons could result • Install Anti-Tip bracket packed with Range • See Anti-Tip bracket Template for Installation Instructions Installation Manual To reduce the risk of tipping the range, it must be secured by properly installed Anti-Tip bracket packed with the range. • This range must be electrically grounded in accordance with local codes, or in their absence, with the National Electrical Code ANSI/NFPA No. 70-latest edition in United States. • The installation of ranges designed for manufactured (mobile) home installation must conform with Manufactured Home Construction and Safety Standard, title 24CFR, part 3280 [Formerly the Federal Standard for Mobile Home Construction and Safety, title 24, HUD (part 280)] or when such standard is not applicable, the Standard for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups), ANSI Z225. 1/NFPA 501A- latest edition, or with local codes in United States. • Make sure the wall coverings and the cabinets around the range can withstand the heat generated by the range. • Before installing the range in an area covered with linoleum or any other synthetic floor covering, make sure the floor covering can withstand heat at least 90˚F (32.2˚C) above room temperature without shrinking, warping or discoloring. Do not install the range over carpeting unless you place an insulating pad or sheet of 1/4-inch (0.64cm) thick plywood between the range and carpeting. Never leave children alone or unattended in the area where an a range is in use. As children grow, teach them the proper, safe use of all appliances. Stepping, leaning or sitting on the door or drawer of this range can result in serious injuries and can also cause damage to the range. • Do not store items of interest to children in the cabinets above the range. Children could be seriously burned climbing on the range to reach items. • To eliminate the need to reach over the cooktop, cabinet storage space above the cooktop should be avoided. • Do not use the oven as a storage space. This creates a potentially hazardous situation. • Never use the range for warming or heating the room. • Do not store or use gasoline or other flammable vapors and liquids near this or any other range. Explosions or fires could result. • Reset all controls to the "off" position after using a programmable timing operation. When using the Self-Clean Feature: • Remove broiler pan, oven racks, food and other utensils before self-cleaning the oven. Wipe up excess spillage. Follow the precleaning instructions in the Operation Manual.