Sharp KB4425LS KB-4425LS , KB-4425LK , KB-4425LW Installation Instructions - Page 7
Installation Manual
UPC - 074000616226
View all Sharp KB4425LS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
FASTEN BRACKET (WALL OR FLOOR MOUNTING) leveling leg max 11/4" wall mount Installation Manual • Adjust the back leveling legs with an adjustable wrench or pliers. Measure from the floor to the bottom of the cooktop glass (X) and adjust the legs to match the measurement (Y) taken from the cutout. See Figure 17. floor mount Figure 14 wall plate Anti-Tip bracket FASTEN BRACKET (FLOOR MOUNTING ONLY) leveling leg more than 11/4" floor mount Figure 15 wall Anti-Tip bracket b Drill Pilot Holes and Fasten bracket Drill a 1/8-inch pilot hole where screws are to be located. If bracket is to be mounted to the wall, drill pilot hole at an approximate 20 degree downward angle. If bracket is to be mounted to masonry or ceramic floors, drill a 5/32-inch pilot hole 1 3/4-inches deep. The screws provided may be used in wood or concrete material. Use a 5/16-inch nut-driver or flat head screwdriver to secure the bracket in place. c Level and Position Range • Measure from the countertop to the floor height to determine the height that the back of the range needs to be set at. • Loosen legs and lock nuts to set level of the range. (Note that the lock nuts are only on the rear feet). See Figure 16. (X") (Y") floor to bottom floor to top off cooktop of countertop glass Figure 17 • After leveling, tighten the lock nuts on the rear to prevent the feet from turning when sliding into position. See Figure 18. Figure 18 NOTE: A minimum clearance of 1/8-inch is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a level to check your adjustments. Plug range into properly prepared electrical receptacle or if hard wired, check that it was completed properly. Check floor condition for evenness and stability. Slide range back into position. See Figure 19. Range Leg Figure 16 Lock Nut (Rear leg only) 1 5/8" to edge of bracket Range Slide Figure 19