Sharp KB4425LS KB-4425LS , KB-4425LK , KB-4425LW Installation Instructions - Page 6
Anti-tip - installation instructions
UPC - 074000616226
View all Sharp KB4425LS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation Manual For 3 & 4-Wire Permanent Connections terminal block line 1 line 2 neutral ground strap 4-Wire Permagnrouennd ptlatCe onnection only ground screw terminal block line 1 Figure 11 line 2 neutral ground strap ground plate ground screw ground plate Anti-Tip ground screw ground NORMAL INSTALLATIONwireSleTaEd PS proper ground for 4-wire permanent Anti-Tip bracket Installation Instructions Important Safety Warning To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed Anti-Tip bracket and screws packed with the range. Failure to install the Anti-Tip bracket will allow the range to tip over if excessive weight is placed on an open door or if a child climbs upon it. Serious injury might result from spilled hot liquids or from the range itself. If range is ever moved to a different location, the Anti-Tip bracket must also be moved and installed with the range. Instructions are provided for installation in wood or cement fastened to either the floor or wall. When installed to the wall, make sure that screws completely penetrate dry wall and are secured in wood or metal. When fastening to the floor or wall, be sure that screws do not penetrate electrical wiring or plumbing. ground plate ground screw ground wire lead proper ground for 4-wire permanent Figure 12 A Locate the bracket - Using the Template The bracket may be located on either the left or right side of the range. Refer to figure 13B to locate the bracket if template is not available. 13 3/8" 13 3/8" 13 3/8" from the center of the wall opening to the edge of the backet. Figure 13A 15" 15" The edge of the template should be aligned with the left or right edge of the range. Figure 13B Mark the floor or wall where left or right side of the range will be located. If rear of range is against the wall or no further than 1 1/4-inches from wall when installed, you may use the wall or floor mount method. See Figure 14. If molding is installed and does not allow the bracket to fit flush against the wall, remove molding or mount bracket to the floor. For wall mount, locate the bracket by placing the back edge of the template against the rear wall and the side edge of template on the mark made referencing the side of the range. Place bracket on top of template and mark location of the screw holes in wall. If rear of range is further than 1 1/4-inches from the wall when installed, attach bracket to the floor. See Figure 15. For floor mount, locate the bracket by placing back edge of the template where the rear of the range will be located. Mark the location of the screw holes, shown in template.