Sharp PN-L401C PN-L401C Quick Start Setup Guide - Page 12
Attach the stand to the monitor, Disassembling the stand
View all Sharp PN-L401C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
nAttach the stand to the monitor 4. Attach the stand to the monitor. Secure from the back with 4 stand mounting screws (M6). Caution • The stand is for use in landscape orientation. It cannot be used for portrait orientation. 1. Attach the stand rods (x2) to the VESA angle. Put the VESA angle with the screw holes face up as below. Attach the stand rods to the VESA angle, and secure it with 4 stand mounting screws (M3). VESA angle Screw holes Stand rods 2. Attach the stand leg to the stand rods. Flip the VESA angle and secure the stand rods and the ends of stand leg with 4 stand mounting screws (M4). nDisassembling the stand 1. Spread a thick, soft cloth (blanket, etc.) that will prevent damage to the LCD panel on a stable flat surface where the entire monitor can be placed, and place the monitor with the LCD panel face down on the cloth. 2. Remove the screws(x4) that fasten the attachment plate, and remove the attachment plate. Stand leg 3. Reverse the stand assembly procedure to disassemble the stand. 3. Spread a thick, soft cloth (blanket, etc.) that will prevent damage to the LCD panel on a stable flat surface where the entire monitor can be placed, and place the monitor with the LCD panel face down on the cloth. Place so that the bottom of the monitor comes to the edge of the table. E 10