Sony BDV-T10 Operating Instructions - Page 91
Additional Information, Operation
UPC - 027242763661
View all Sony BDV-T10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Symptom Remedy The surround effect is difficult to • Check the decoding mode setting (page 33). hear when you are playing a • Check the speaker connections and settings (pages 20, 67). sound track of Dolby Digital, DTS, or MPEG audio. • Depending on the BD/DVD, the output signal may not be the entire 5.1 channel. It may be monaural or stereo even if the sound track is recorded in Dolby Digital or MPEG audio format. The sound comes from the center • Depending on the disc, the sound may come from the center speaker only. speaker only. No sound is heard from the center speaker. • Check the speaker connections and settings (pages 20, 67). • Check the decoding mode setting (page 33). • Depending on the source, the effect of the center speaker may be less noticeable. • A 2 channel source is being played. No sound or only a very lowlevel sound is heard from the surround speakers. • Check the speaker connections and settings (pages 20, 67). • Check the decoding mode setting (page 33). • Depending on the source, the effect of the surround speakers may be less noticeable. • A 2 channel source is being played. The beginning of the sound is cut • Set the sound mode to "MOVIE" or "MUSIC" (page 47). off. • Select "A.F.D. STD" for the decoding mode (page 33). The sound effects are disabled. • The effects of SOUND MODE, DYNAMIC BASS, NIGHT, "TONE," and "DEC. MODE" may be disabled depending on the input stream (page 79). Distortion occurs in the sound of • Reduce the input level for the connected component by setting [Attenuate - TV] a connected component. or [Attenuate - AUDIO] (page 78). Operation Symptom Radio stations cannot be tuned in. Noise is heard on AM radio. The remote does not function. Remedy • Check that the antenna (aerial) is connected securely. Adjust the antenna (aerial) or connect an external antenna (aerial) if necessary. • The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning. • No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 51). • Press DISPLAY so that the frequency appears in the front panel display. • Check the location of the AM loop antenna (aerial) and cord (page 25). • There are obstacles between the remote and the unit. • The distance between the remote and the unit is too far. • The remote is not pointed at the remote sensor on the unit. • The batteries in the remote are weak. • When you cannot perform menu operations via the front panel display, press HOME on the remote. Additional Information 91US