Sony CDX-GT720 Operating Instructions - Page 5
Detaching the front panel, Inserting the disc in the unit, Ejecting the disc
View all Sony CDX-GT720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Detaching the front panel You can detach the front panel of this unit to prevent theft. Caution alarm If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the built-in amplifier is used. 1 Press (OFF). The unit is turned off. 2 Press . The left side of front panel is released. 3 Slide the front panel to the left, then gently pull out the front panel towards you. (OFF) Notes • Do not drop or put excessive pressure on the front panel and display window. • Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray. Attaching the front panel Place the hole A of the front panel onto the spindle B on the unit, then lightly push the left side in. Press (SOURCE) on the unit (or insert a disc) to operate the unit. A B Note Do not put anything on the inner surface of the front panel. Inserting the disc in the unit 1 Press Z. The front panel slides down automatically. 2 Insert the disc (label side up). The front panel slides up automatically, then playback starts automatically. Ejecting the disc 1 Press Z. The front panel slides down automatically, then the disc is ejected. 2 Press Z to close the front panel. Note The front panel slides up automatically after 15 seconds of the front panel sliding down. Adjusting the angle of the front panel (ANGLE) 1 Press and hold (ANGLE) repeatedly until the front panel is angled accordingly. The front panel can be set to 3 positions. To return the front panel to its default position, press and hold (ANGLE) repeatedly until the front panel is returned to its default position. Tips • After the front panel slides down (to insert the disc), it returns to the position you set again automatically. • The front panel angle you set is stored in the unit. When turning the ignition off, the angle returns to its default position, then turning the ignition on, the front panel is angled you set. 5