Sony CMT-HPX7 Operating Instructions - Page 23

Optional Components, Hooking up optional components

Get Sony CMT-HPX7 PDF manuals and user guides View all Sony CMT-HPX7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Optional Components Hooking up optional components To enhance your system, you can connect optional components. Refer to the operating instructions provided with each component. From the audio output jacks of an optional analog component Optional analog component Display/Optional Components A MD/VIDEO jacks Use audio cords (not supplied) to connect an optional analog component (MD deck, etc.) to these jacks. You can then listen to the sound from the component. Listening to audio from a connected component 1 Connect audio cords. See the illustration above. 2 Press FUNCTION repeatedly until "MD" or "VIDEO" appears. Start playing the connected component. Tip If you cannot select "VIDEO" by pressing FUNCTION repeatedly, turn off the system and then press ?/1 on the unit while holding down FUNCTION on the unit. The function will change from "MD" to "VIDEO", and "VIDEO" will appear in the display. To change back to "MD", repeat the same procedure. However, you cannot switch the MD/VIDEO function in Power Saving Mode. 23GB

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
Display/Optional Components
23
GB
To enhance your system, you can connect optional components. Refer to the operating instructions
provided with each component.
A
MD/VIDEO jacks
Use audio cords (not supplied) to connect an
optional analog component (MD deck, etc.) to
these jacks. You can then listen to the sound
from the component.
Listening to audio from a
connected component
1
Connect audio cords.
See the illustration above.
2
Press FUNCTION repeatedly until “MD” or
“VIDEO” appears.
Start playing the connected component.
Tip
If you cannot select “VIDEO” by pressing
FUNCTION repeatedly, turn off the system and then
press
?/1
on the unit while holding down FUNCTION
on the unit. The function will change from “MD” to
“VIDEO”, and “VIDEO” will appear in the display. To
change back to “MD”, repeat the same procedure.
However, you cannot switch the MD/VIDEO function
in Power Saving Mode.
Optional Components
Hooking up optional components
Optional analog component
From the audio output
jacks of an optional
analog component