Sony DCR-TRV15 Operating Instructions - Page 149
Types of trouble and their solutions
View all Sony DCR-TRV15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
Troubleshooting - Troubleshooting - Types of trouble and their solutions If you run into any problem using your camcorder, use the following table to troubleshoot the problem. If the problem persists, disconnect the power source and contact your Sony dealer or local authorized Sony service facility. If "C:ss:ss" appears on the screen or the self-diagnosis display function has worked. See page 155. In the recording mode Symptom Cause and/or Corrective Actions START/STOP does not operate. • The POWER switch is not set to CAMERA. c Set it to CAMERA. (p. 21) • The tape has run out. c Rewind the tape or insert a new one. (p. 20, 33) • The write-protect tab is set to expose the red mark. c Use a new tape or slide the tab. (p. 20) • The tape is stuck to the drum (moisture condensation). c Remove the cassette and leave your camcorder for at least one hour to acclimatize. (p. 165) The power goes off. • While being operated in CAMERA mode, your camcorder has been in the standby mode for more than five minutes. c Set the POWER switch to OFF (CHG) and then to CAMERA. (p. 21) • The battery pack is dead or nearly dead. c Install a charged battery pack. The image on the viewfinder is not clear. • The viewfinder lens is not adjusted. c Adjust the viewfinder lens. (p. 24) The SteadyShot function does not work. • STEADYSHOT is set to OFF in the menu settings. c Set it to ON. (p. 97) The autofocusing function does not work. • The setting is the manual focus. c Press FOCUS to set to the auto focus mode. (p. 53) • Shooting conditions are not suitable for autofocus. c Adjust to focus manually. (p. 53) The picture does not appear in the viewfinder. • The LCD panel is open. c Close the LCD panel. (p. 22) A vertical band appears when you shoot a subject such as lights or a candle flame against a dark background. • The contrast between the subject and background is too high. Your camcorder is not a malfunction. A vertical band appears when you shoot a very bright subject. • Your camcorder is not a malfunction. Some tiny white spots appear on the • Slow shutter, low lux or Super NightShot mode is screen. activated. This is not a malfunction. An unknown picture is displayed on the screen. • If 10 minutes elapse after you set the POWER switch to CAMERA or DEMO MODE is set to ON in the menu settings without a cassette inserted, your camcorder automatically starts the demonstration. c Insert a cassette and the demonstration stops. You can also cancel DEMO MODE. (p. 101) (continued on the following page) 149