Sony DCR TRV520 Operating Instructions - Page 110

Troubleshooting In the recording and playback modes Symptom Cause and/or Corrective Actions The power does not turn on. • The battery pack is not installed, or is dead or nearly dead. c Install a charged battery pack. (p. 10, 11) • The AC power adaptor is not connected to a wall outlet. c Connect the AC power adaptor to a wall outlet. (p. 14) The end search function does not work. • The tape was ejected after recording. • You have not recorded on the new cassette yet. The end search function does not work correctly. • The tape has a blank portion in the beginning or middle. The battery pack is quickly discharged. • The operating temperature is too low. • The battery pack is not fully charged. c Charge the battery pack fully again. (p. 11) • The battery pack is completely dead, and cannot be recharged. c Replace with a new battery pack. (p. 10) The battery remaining indicator does not indicate the correct time. • You have used the battery pack in an extremely hot or cold environment for a long time. • The battery pack is completely dead, and cannot be recharged. c Replace with a new battery pack. (p. 10) • The battery is dead. c Use a charged battery pack. (p. 10, 11) The power goes off although the battery remaining indicator indicates that the battery pack has enough power to operate. • Charge the battery pack fully again so that the indication on the battery remaining indicator is correct. The cassette cannot be removed from the holder. The % and Z indicators flash and no functions except for cassette ejection work. • The power source is disconnected. c Connect it firmly. (p. 11, 14) • The battery is dead. c Use a charged battery pack. (p. 10, 11) • Moisture condensation has occurred. c Remove the cassette and leave your camcorder for at least 1 hour to acclimatize. (p. 117) 110