Sony DHG-M55CV Installation Guide - Page 16

Introducing the Digital Network Receiver Programming the Wireless Keyboard The keyboard is preset at the factory to operate any Sony brand TV. If you have any other brand of TV, use the following procedures to program the keyboard to use any of the highlighted buttons shown on page 8. To program the keyboard 1 Set the keyboard's TV/CABLE switch to TV. 2 Turn to "Wireless Keyboard Programmable Codes" on page 13, and find the 3-digit code for your TV. If more than one code is listed, use the number listed first to complete the following procedures. 3 Press the CODE SET button. 4 Enter the 3-digit code for your TV using the 0-9 keys. 5 Press the OK/Enter key. To check if the code works 1 Aim the keyboard at the TV and press TV POWER. 2 If the TV responds, try the VOLUME and MUTE buttons. If the TV responds, you're done. If the TV does NOT respond ❑ Try programming the keyboard using the other codes listed for your TV brand. ❑ If you still cannot get your TV to respond after trying all the codes, your TV may not be compatible with this keyboard. If this happens, you must use your TV's remote to operate it. Positioning the Keyboard The keyboard functions like a remote control. To use it, just point it at the front panel of the Digital Network Receiver. For best results, the keyboard should be used within 30 feet of the Digital Network Receiver, at no more than a 45° angle. Adjusting the Keyboard Legs To raise the legs on the keyboard, use your finger to pry up the adjustable legs on the bottom of the keyboard until you feel them lock into place. To lower the keyboard, push each leg down until it snaps into the closed position. 10