Sony DSX-GS80 Operating Instructions - Page 13

Connection/Installation Cautions • Run all ground (earth) leads to a common ground (earth) point. • Do not get the leads trapped under a screw, or caught in moving parts (e.g., seat railing). • Before making connections, turn the car ignition off to avoid short circuits. • Connect the yellow and red power supply leads only after all other leads have been connected. • Be sure to insulate any loose unconnected leads with electrical tape for safety. • Choose the installation location carefully so that the unit will not interfere with normal driving operations. • Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperature, such as in direct sunlight or near heater ducts. • Use only the supplied mounting hardware for a safe and secure installation. Note on the power supply lead (yellow) When connecting this unit in combination with other stereo components, the amperage rating of the car circuit to which the unit is connected must be higher than the sum of each component's fuse amperage rating. Note on installing in cars with a start-stop system The unit may restart when starting the engine from start-stop. In this case, turn off the start-stop system of your car. Mounting angle adjustment Adjust the mounting angle to less than 30°. Parts List for Installation  Mounting sleeve (1)  Release keys (2)  Trim ring (1)  Mounting screws (5 × max. 8 mm (7/32 × max. 5/16 in)) (4)  Power supply leads (1)  Microphone (1)  Flat-mount base (1)  Double-sided tape (1) • This parts list does not include all the package contents. • The mounting sleeve  and the trim ring  are attached to the unit before shipping. Before mounting the unit, use the release keys  to remove the mounting sleeve  from the unit. For details, see "Removing the trim ring and the mounting sleeve" (page 17). • Keep the release keys  for future use as they are also necessary if you remove the unit from your car. 13GB