Sony DSX-GS80 Help Guide - Page 60
SPEAKER LOAD speaker impedance load, USB AUTOPLAY USB auto play, USB MODE USB mode
View all Sony DSX-GS80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Registers/resets the setting of the steering wheel remote control. (Available only while the source is off and the clock is displayed.) Item Detail STRG CONTROL (steering control) Selects the input mode of the connected remote control. To prevent a malfunction, be sure to match the input mode with the connected remote control before use. [CUSTOM] (custom) Input mode for the steering wheel remote control. [PRESET] (preset) Input mode for the wired remote control excluding the steering wheel remote control. (Automatically selected when [RESET CUSTOM] is performed.) EDIT CUSTOM (edit custom) Registers the functions (SOURCE, ATT (attenuate), VOL (volume) +/-, SEEK +/-, VOICE, ON HOOK, OFF HOOK) to the steering wheel remote control: Rotate the control dial to select the function you want to assign to the steering wheel remote control, then press it. While [REGISTER] is blinking, press and hold the button on the steering wheel remote control you want to assign the function to. When registration is complete, [REGISTERED] is displayed. To register other functions, repeat steps and . (Available only when [STRG CONTROL] is set to [CUSTOM].) RESET CUSTOM (reset custom) Resets the registered functions of the steering wheel remote control: [YES], [NO]. (Available only when [STRG CONTROL] is set to [CUSTOM].) Note While making settings, only button operation on the unit is available. For safety, park your car before making this setting. If an error occurs while registering, all the previously-registered information remains. Restart registration from the function where the error occurred. This function may not be available on some vehicles. For details on the compatibility of your vehicle, visit the support site. SPEAKER LOAD (speaker impedance load) Sets the impedance load of the speaker connection: [4 OHM] (4 Ω load connection), [2 OHM] (2 Ω load connection). (Available only while the source is off and the clock is displayed.) Set to [2 OHM] when connecting as follows: - When connecting front speakers in parallel. - When connecting subwoofer(s) to right and left rear speaker leads. - When connecting a dual voice coil subwoofer with 4 Ω to 8 Ω impedance. USB AUTOPLAY (USB auto play) Activates the USB auto play: [ON], [OFF]. USB MODE (USB mode) Changes the USB mode: [ANDROID], [MSC/MTP]. (Available only when the USB is selected.) 60