Sony HT-ST7 Operating Instructions - Page 17

Adjusting the settings / Configuration des réglages MENU / ENTER RETURN Press MENU on the remote control, then select the desired setting using //ENTER/RETURN. LEVEL AUDIO HDMI SET BT Menu DRC (DYNAMIC RANGE CONTROL) SYNC (AV SYNC) DUAL (DUAL MONO) S. OPT (SOUND OPTIMIZER) HEQ (HARMONICS EQUALIZER) AAV (ADVANCED AUTO VOLUME) CTRL (CONTROL FOR HDMI) P. THRU (PASS THROUGH) ARC (AUDIO RETURN CHANNEL) BT.STBY (BLUETOOTH STANDBY) AAC (ADVANCED AUDIO CODING) Function You can enjoy Dolby Digital sound at low sound volumes. (ON/AUTO/OFF) ON: Compresses sound in accordance with the compression information contained in the content. AUTO: Automatically compresses sound encoded in Dolby TrueHD. You can adjust the sound when the image and the sound are not in sync. (1 - 4/ OFF) You can enjoy multiplex broadcast sound of Dolby Digital audio. (M/S (main and sub channels)/MAIN (main channel)/SUB (sub channel)) Adjusts the sound so that it is reproduced dynamically and more clearly even at low sound volumes. (ON/OFF) Reproduces the very low volume sounds that tend to be eliminated by audio compression. (ON/OFF) Note: HEQ functions only when "BT AU" is selected. This does not function with any other inputs, even though the item is displayed on the front panel. Reduces the volume discrepancies between different programs or between programs and commercials. (ON/OFF) Switches the Control for HDMI function on or off. (ON/OFF) Sets the power saving mode of the pass-through function of HDMI signals. (AUTO/ON) AUTO: Outputs signals from the HDMI OUT TV (ARC) jack of the system in standby mode when the TV is turned on. This setting saves power in standby mode compared with the "ON" setting. ON: Always outputs signals from the HDMI OUT TV (ARC) jack in standby mode. Note: This item appears only when "CTRL (CONTROL FOR HDMI)" is set to "ON." Allows you to listen to digital sound from a TV compatible with the Audio Return Channel (ARC) technology is connected using an HDMI cable. (ON/OFF) Note: This item appears only when "CTRL (CONTROL FOR HDMI)" is set to "ON." When the system has pairing information, the system is in BLUETOOTH standby mode even when it is turned off. (ON/OFF) Note: During BLUETOOTH standby mode, the BLUETOOTH indicator flashes in blue slowly. Sets whether or not the system will use AAC via BLUETOOTH. (ON/OFF) Note: If you change the setting when the system is connected with a BLUETOOTH device, the system will be disconnected from the device. Default AUTO OFF MAIN OFF ON OFF ON AUTO ON OFF OFF 17