Sony KV-27HS420 Operating Instructions - Page 38

SETUP SETUP Remote Control Programming the Remote Control If you have video equipment other than Sony brand (or if you have a Sony DVD/VCR combination unit) that you want to control with the TV's remote control, use the following procedure to program the remote control. ✍ The equipment must have infrared (IR) remote capability in order to be used with the remote control. 1 Turn to the list of "Manufacturer's Codes" on page 38, and find the three-digit code number for the manufacturer of your equipment. (If more than one code number is listed, use the number listed first.) 2 Press CODE SET. 3 Press the VCR/DVD FUNCTION or SAT/CABLE FUNCTION button. 4 Using the 0-9 buttons, enter the three-digit manufacturer's code number. 5 Press the ENTER button. ✍ You must do step 5 within 10 seconds of step 4, or you must redo steps 2 through 5. 6 To check if the code number works, aim the TV's remote control at the equipment and press the POWER button that corresponds with that equipment. If it responds, you are done. If not, try using another code listed for that manufacturer. Notes ❑ If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment. ❑ If you enter a new code number, the code number you previously entered at that setting is erased. ❑ In some cases, you may not be able to operate your equipment with the supplied remote control. In such cases, use the equipment's own remote control. ❑ Whenever you remove the batteries to replace them, the code numbers may revert to the factory setting and must be reprogrammed. SETUP SETUP SETUP 37