Sony SPP-A972 Operating Instructions - Page 75
Additional Information, Symptom, Phone Directory, Answering machine, Operating from an, outside phone
View all Sony SPP-A972 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
buttons LINE 1 and 2 Phone Directory Intercom Symptom LINE 1 or 2 button flashes when not in use. Remedy • Either the handset or the base unit is being used. You hear five short error beeps and cannot store a number in the Phone Directory. • Make sure you follow the procedure for storing the number correctly (pages 32). • Make sure the number (including the tone and pause digits) does not exceed 32 digits. Phone Directory dialing is incorrect. • Store the correct number (pages 32). The handset does not ring • The battery may be weak. Charge the battery for more when you use the intercom than 12 hours (page 14). from the base unit, and the base • Move the handset closer to the base unit. unit does not ring when you • Place the base unit away from noise sources use the intercom from the (page 10). handset. When pressing (INTERCOM), you hear a busy tone and cannot make an intercom call. • Either the base unit or handset is being used to converse with an outside caller. Message is not recorded. • The remaining recording time is less than 30 seconds or 99 messages were recorded. The answering machine becomes "Memory full" status and does not record messages. Erase messages (page 55). • The message is less than two seconds. The answering machine does not record messages less than two seconds in length. No sound from the speaker of the base unit. The caller's message is interrupted. • Adjust the speaker volume (page 55). • The caller's message is too long. • The caller's voice is too low. The unit disconnects the line when it detects seven seconds of silence. The clock is incorrect. • There was a power interruption. Reset the time (page 47). The phone does not accept your • Make sure you call from a touch-tone phone. remote ID code (security code). • Make sure the remote ID code (security code) is correct. • Make sure you entered the remote ID code (security code) within two seconds after you've entered (#). The line is disconnected when you call your phone from a touch-tone phone. • You entered wrong remote ID codes (security codes) three times. Answering machine Operating from an outside phone Additional Information continued Additional Information 75US