Sony SS-CNP700 Operating Instructions - Page 22

Error and warning codes Error codes When an error is detected during Auto Calibration, an error code will appear on the display cyclically after each measurement process as follow: Error code t blank display t (error code t blank display)a) t PUSH t blank display t ENTER a)Appears when there are more than one error code. To rectify the error 1 Record down the error code. 2 Press the control button. 3 Press ?/1 to turn off the receiver. 4 Rectify the error. For details, see "Error code and remedies" below. 5 Turn on the receiver and perform Auto Calibration again (page 21). Error code and remedies Error code Explanation Remedies ERROR 10 The environment Make sure the is too noisy. environment is quiet during Auto Calibration. ERROR 11 The speakers are Place your speakers placed too near further away from the optimizer the optimizer microphone. microphone. ERROR 20 The front Check the front speakers are not speakers detected or only connection. one front speaker is detected. ERROR 21 Only one Check the surround surround speaker speakers is detected. connection. Warning codes During Auto Calibration, the warning code provides information on the measurement result. The warning code will appear on the display cyclically as follows: Warning code t blank display t (warning code t blank display)b) t PUSH t blank display t ENTER b)Appears when there are more than one warning code. You can choose to ignore the warning code as the Auto Calibration function will automatically adjust the settings. You can also change the settings manually. To change the settings manually 1 Record down the warning code. 2 Press the control button. 3 Press ?/1 to turn off the receiver. 4 Follow the solution provided in the "Warning code and solution" (page 23). 5 Turn on the receiver and perform Auto Calibration again (page 21). 22US