Sony XAV-AX4000 Operating Instructions - Page 11
Rear View Camera Connection, Memory hold connection, Speaker connection, Making connections
View all Sony XAV-AX4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
*1 Not supplied *2 Speaker impedance: 4 Ω to 8 Ω × 4 *3 RCA pin cord (not supplied) *4 Power amplifier (not supplied) *5 Subwoofer (not supplied) *6 Depending on the type of car, use an adaptor for a steering wheel remote control (not supplied). For details on using the steering wheel remote control, see "Using the steering wheel remote control" (page 13). *7 Depending on the type of car, use an adaptor (not supplied) if the antenna (aerial) connector does not fit. *8 Whether in use or not, route the microphone input cord so it does not interfere with driving operations. Secure the cord with a clamp, etc., if it is installed around your feet. *9 For details on installing the microphone, see "Installing the microphone" (page 12). *10 For more information on how to install the SiriusXM Connect Vehicle Tuner, consult the installation guide supplied with the tuner. *11 When connecting the iDataLink Maestro module (not supplied), do not connect any device to the REMOTE IN terminal (blue). Likewise, when connecting a device to the REMOTE IN terminal (blue), do not connect the iDataLink Maestro module (not supplied) to the IDATA LINK I/F terminal (black). *12 Use the connection cable supplied with the iDataLink Maestro module (not supplied). *13 Connect when using Apple CarPlay with a wireless connection. Making connections To a common ground (earth) point First connect the black ground (earth) lead then connect the yellow and red power supply leads. To the +12 V power terminal which is energized at all times Be sure to first connect the black ground (earth) lead to a common ground (earth) point. To the +12 V power terminal which is energized when the ignition switch is set to the accessory position Be sure to first connect the black ground (earth) lead to a common ground (earth) point. To the power antenna (aerial) control lead or the power supply lead of the antenna (aerial) booster It is not necessary to connect this lead if there is no power antenna (aerial) or antenna (aerial) booster, or with a manually-operated telescopic antenna (aerial). To AMP REMOTE IN of an optional power amplifier This connection is only for amplifiers and a power antenna (aerial). Connecting any other system may damage the unit. Note It will take about 10 seconds to shut down the output of REM OUT after the unit is turned off. To a car's illumination signal Be sure to first connect the black ground (earth) lead to a common ground (earth) point. To the parking brake switch lead The mounting position of the parking brake switch lead depends on your car. Be sure to connect the parking brake lead (light green) of the power supply leads to the parking brake switch lead. Parking brake switch lead Hand brake type Foot brake type To the +12 V power terminal of the car's rear lamp lead (only when connecting the rear view camera) To a car's speed pulse signal When using Apple CarPlay with a wireless connection, it is necessary to connect to keep the accurate location of your car. The mounting position of the speed pulse output lead depends on your car. Rear View Camera Connection Installation of a rear view camera (not supplied) is required before use. Connect a rear view camera power cord (lead) to the accessory power terminal. Memory hold connection When the yellow power supply lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. Speaker connection • Before connecting the speakers, turn the unit off. • Use speakers with an impedance of 4 Ω to 8 Ω, and with adequate power handling capacities to avoid damage. 11GB