Sony XAV C1 Installation/Connections - Page 6

Connecting Information For details, see the section "1 Car Systems Connections" (next page). Connecting the cords Notes • Be sure to connect the power input cord after all other cords are connected. • If the parking brake switch cord is too thin, connect the parking cord to the parking brake switch cord directly without using the tap. Connect each cord using the taps. For the combination of each cord, see the following table. Also, see the section "1 Car Systems Connections" (next page). Main unit side Orange/white Purple/white Light green Car side Illumination signal cord Power terminal cord of the back lamp Parking brake switch cord Using the tap Parking brake switch cord Tap 9 Parking cord (Light green) Connecting the parking cord The mounting position of the parking brake switch cord depends on your car. Refer to the system connection illustrations below and consult your car dealer or your nearest Sony dealer for further details. Foot brake type Parking brake switch cord Hand brake type Parking brake switch cord The cord for utilizing the back camera better Purple/white cord (for the connection to the power terminal cord of the back lamp) If you connect the purple/white cord to the power terminal cord of the back lamp, the image of back camera will be automatically displayed on the monitor when a back lamp lights up. You can adjust the parking location viewing the image of back camera when you backup. 6